VARTEK Corporation Home VARTEK Corporation  
Home Contact Us Precision Equipment Specifications Company History
VARTEK Corporation

  SPECIFICATIONS
MODEL TC1015-2
DC PROPORTIONAL TEMPERATURE CONTROLLER
 		  
OUTPUTS:
          OUTPUT 1:
          OUTPUT 2:
          OUTPUT 3:
Block heater output
Component heater output
The channel provides an audible, visual and contact closure alarm when preset temperature is above or below a limit. This limit is selected for +/- 1 degree or +/- 10 degrees or by defeat alarms via a front panel three position switch.
 
OUTPUT VOLTAGES:
          OUTPUT 1:
          OUTPUT 2:
DC
DC
 
OUTPUT POWER:
          OUTPUT 1:
          OUTPUT 2:
60 Watts
15 Watts
 
SENSOR SET POINT RESISTANCE:
          BLOCK CHANNEL:
          SENSOR CHANNEL:
Nominal 470 ohms at 0 degC
Nominal 595 ohms at operating temperature 68 deg C.
          NOTE: Sensor and resistance balance arm will both be physically located on unit under control.
 
SET POINT STABILITY:*
          Vs. TIME:
          Vs. TEMP:
+/-0.1 deg C/24 hrs @ constant temperature.
+/-0.05 deg/deg C
 
HUM AND NOISE: No frequencies of 100KHz or greater shall be generated by the controller with the controlled system on the fine heater or sensor lines.
 
AMBIENT TEMPERATURE: 15 deg C to 50 deg C
 
INPUT POWER: 115V +/-10V, 60Hz
 
FRONT PANEL METERS:
          1. Component temperature deviation meter
          2. Block heater hi/low temperature meter
          3. Fine Heater Indicator (white)
 
FRONT PANEL CONTROLS:
          1. Two Range Monitor Sensitivity Switch:
                    Range I: +/- one degree sensitivity
                    Range II: +/- ten degree sensitivity
 
          2. Low Alarm Set Switch:
                    Position 1: OFF
                    Position 2: 1 degree
                    Position 3: 10 degrees
 
          3. High Alarm Set Switch:
                    Position 1: OFF
                    Position 2: 1 degree
                    Position 3: 10 degrees
 
FRONT PANEL INDICATORS:
          1. High Temperature RED indicator
          2. Low Temperature GREEN indicator
 
PHYSICAL: 8.75 maximum standard 19" Rack panel mount.
 
Back to Top
Home - Contact Us - International Contact - Precision Equipment - Specifications - Company History
Vartek Corporation
420 South Perry Lane - Suite 5
Tempe, Arizona 85281 U.S.A.